Did You Know

Did you know...

Adhesive coaters and specialty graphics printers are turning to Argotec films for their unmatched optical clarity, lay-flat, UV resistance, and paintlike gloss finish.

ARGOGRAPH™ TECHNICAL DATA TABLE Typical Physical Properties

Argotec
Number		 Film Type
Description		 Physical
Property		 Test
Method		 Units Test
Value
18248
[click to download tech data sheet]
  • Thermoplastic polyurethane
  • Aromatic polyether
  • Uses: industrial, UV exposure, graphics
  • Extrusion method: blown film
  • Gauge: 1.0-10 mils (25-250 microns)
  • Width: up to 68 inches (2.18 meters)
  • Length: up to 1000 non-spliced yards
  • Smooth surface
  • Soft ether
  • Mid-range softening temperature
  • UV stabilized
 Hardness D-224 Shore 85 A
Tensile stress @ 100% elongation D-412 psi
MPa		 990
6.8
Tensile stress @ 300% elongation psi
MPa		 1750
12.1
Tensile strength psi
MPa		 7000
48.3
Elongation @ break % 570
Tensile set @ 200% E % 21
Tear strength D-6241 pli
kN/m		 475
83.2
Abrasion resistance D-10445 mg loss 5
46510
[click to download tech data sheet]
  • Thermoplastic polyurethane
  • Aliphatic polycaprolactone
  • Uses: paint & metal protection
  • Extrusion method: flat die
  • Gauge: 2-15 mils (50-375 microns)
  • Width: up to 75 inches (1.91 meters)
  • Length: up to 1000 non-spliced yards
  • Smooth and matte surfaces
  • Hardest polycaprolactone
  • UV resistant
  • No additives
 Hardness D-224 Shore 60 D
Tensile strength D-412 psi 7000
Elongation at break % 450
Gloss 60° 450
UV resistance A101 No change
at 3000 hours
49510
[click to download tech data sheet]
  • Thermoplastic polyurethane
  • Aliphatic polycaprolactone
  • Uses: paint & metal protection
  • Extrusion method: flat die
  • Gauge: 2-15 mils (50-375 microns)
  • Width: up to 75 inches (1.91 meters)
  • Length: up to 1000 non-spliced yards
  • Smooth and matte surfaces
  • Hard polycaprolactone
  • UV resistant
  • No additives
 Hardness D-224 Shore 93 A
Tensile strength D-412 psi 5000
Elongation at break % 550
Gloss 60° 450
UV resistance A101 No change
at 3000 hours

1 Die C.
2 Taber abrasion H-22 wheel, 1000 gm weight, 1000 cycles.
3 Taber abrasion H-18 wheel, 1000 gm weight, 1000 cycles.
4 Taber abrasion H-17 wheel, 1000 gm weight, 1000 cycles.
5 Taber abrasion CS-17 wheel, 1000 gm weight, 1000 cycles.